Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 371)

AlliedView™-EMS 3.11 Device Management Guide Page 371 of 402
Note - AT-RG600 Ethernet: If a user account is created without a password, expect
the default value of the Password parameter to be whatever the value of the Name
parameter is.
Note - AT-RG613BD/LH/SH: The current firmware version accepts up to 81
characters for the Comment parameter. Attempting to enter more than 81
characters will cause the device to restart and will eventually result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred."
Battery Backup Info
Displays power backup status such as the Backup Battery Status and Backup Primary
Status
Reset
Resets the residential gateway.
CPE Config Save
Saves the configuration made in the residential gateway.
Note - The CPE Config Save option does not save the changes made to the
configuration file.
Telnet
Starts a Telnet connection to the residential gateway.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as forwarding
database, aging time info and Quality of Service (QoS) info.
Forwarding Database
Displays the Forwarding Database table.
Aging Time Info
Displays information about the aging time status, mode, and value.
Note - AT-RG613xx/AT-RG600 ADSL: The Aging Time Value parameter has a fixed
value of 0 and cannot be modified.
Note - AT-RG656BD : Changing the value of the Aging Time Mode parameter causes
the Aging Time Value parameter to be set to 0.
Note - AT-RG656BD : Valid MIB Set values for the Aging Time Value parameter are
in the range [0-2147483647] inclusive. However, the current firmware version
truncates entered values to 7 digits.