Security menu – Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 223

AlliedView™-EMS 3.11 Device Management Guide
Page 223 of 402
Note
- Valid MIB Set values for the Data Pattern parameter should range from 1 to
4294967295. However, the current firmware version does not allow Device
Manager to display the correct value greater than 2147483647. Attempting to enter
values greater than 2147483647 will cause the new value to be converted to the
following values:
4286578688 - 4294934527: 8388608 - 16744447
4294934528 - 4294967167: 32768 - 65407
4294967168 - 4294967295: 128 - 255
Note
- Device Manager does not handle objects of type OCTET STRING correctly.
As a result, the Address parameter will not be configurable and will display a
sequence of bytes in hexadecimal format instead of the actual destination of ping
packets.
Ping Statistics
Displays statistics of the Ping polling.
Security Menu
From the Security menu, you can view and edit port access entity information such as the
PAE port information and the Supplicant PAE information.
Port-based Authentication
Authentication Status
Displays the status of the port-based authentication.
PAE Port Info
Standard
Displays standard PAE port information.
Note
- Device Manager does not handle objects of type BITS correctly. As a result,
the Capabilities parameter will display an 8-bit binary string instead of the actual PAE
functionality supported. However, the PAE functionality supported can still be
determined by looking at the bits that are on from right to left:
Bit 0 - Authenticator
Bit 1 - Supplicant
Enterprise
Displays enterprise PAE port information.
Authenticator PAE Info
Standard
Displays standard authenticator PAE information.
Note
- The Administrative Controlled Directions and Key Transmission Status
parameters are implemented as 'read-only'.