Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 296)

AlliedView™-EMS 3.11 Device Management Guide Page 296 of 402
Displays various applications that can be used to execute authentication such as
console, telnet, HTTP and SSH.
Server Group Info
Displays information about server groups.
Note - For user-defined server groups, the only valid MIB Set value for the Row
Status parameter is ‘destroy’. Attempting to set this parameter to any other value
will result in the error message: ”The error occurred with 'Set' operation. Error:
bad value.”
Server Info
Displays information about servers.
Note - The current firmware version does not allow the Authentication Key
parameter to be configured.
Note - The only valid MIB Set value for the Row Status parameter is ‘destroy’.
Attempting to set this parameter to any other value will result in the error message:
”The error occurred with 'Set' operation. Error: bad value.”
Access Control List
Ethernet Info
Displays ACL mask of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Filtered Ports
o
Source MAC Address Mask
o
Destination MAC Address Mask
Ethernet Rule
Displays ACL rule of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
VLAN
o
Source MAC Address
o
Destination MAC Address
o
Ethernet Type
IP Info
Displays ACL mask of IP information.
Note - The current firmware version does not allow the following parameters to be
configured: