Bridge menu, Adsl menu – Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 125

AlliedView™-EMS 3.11 Device Management Guide
Page 125 of 402
TCP Statistics
Displays TCP statistics.
Note
- The current firmware version does not allow the user to configure the TCP
Connection State parameter. Attempting to configure this parameter will result in
the error message: "The error occurred with 'Set' operation. Error: bad value."
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database, discard/aging time information, and spanning tree status.
Forwarding Database
Displays the Forwarding Database table.
Discard Aging Time Info
Displays information about the number of address entries that were learned but
discarded because either there was a lack of memory or the entry's aging timer
expired.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
ADSL Menu
From the ADSL menu, you can view and edit ADSL information such as the line attributes,
physical layer components, channel information, performance statistics, and configuration
profiles.
Note
- The ADSL Menu does not apply to the AT-AR255E.
ADSL Line
Displays attributes of the ADSL line.
Note
- The current firmware version does not allow the Configuration Profile and
the Alarm Configuration Profile parameters to be configured. Attempting to
configure these will result in the error message: "The error occurred with 'Set'
operation. Error: gen Error."
ATU Remote
ATUR Physical Layer Inventory
Displays the physical layer parameters of each remote ADSL transmission unit.
ATUR Channels
Displays ATUR Channel information like interleave delay, transmit rate, and length
of the channel data-block.