Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 375)

AlliedView™-EMS 3.11 Device Management Guide Page 375 of 402
Port Menu
From the Port menu, you can view and edit MIB information about the ethernet and voice
ports.
Utilization
Displays the port's utilization information.
Note - AT-RG613xx: The Utilization field is grayed out if the Port Speed and Mode
parameter is set to auto-negotiate.
Interface Info
Ethernet
Displays ethernet port statistics such as the number of frames received and
transmitted on the port, bytes received and transmitted on the port and port status.
Note - Valid MIB Set values for the Port Speed and Mode parameter of the 100Base-
FX WAN ports should only be '100Mbps full-duplex', '100Mbps half-duplex', and
'auto sense'. However, the current firmware version allows it to be set to '10Mbps
full-duplex' or '10Mbps half-duplex' as well.
Note - Under the Additional Info sub-menu option, if the Port Speed and Mode
parameter is currently set to '100Mbps full-duplex', it cannot be changed to
'100Mbps half-duplex' directly. You will have to set it to some other speed and
mode first. This is true for all LAN and WAN ports.
Note - The Port Flow Control parameter has a fixed value of 'flow' and cannot be
modified.
Note - Port number assignment displayed in the Additional Info and Standard Info
sub-menu options are inconsistent.
Note - The current firmware version does not return any value for the Physical
Address parameter.
Note - Changing the value of the Port Speed and Mode parameter will result in the
error message: "The error occurred with 'Set' operation. Error: time out occurred."
However, the new value is still set.
Note - It may take a while before the actual values of the Port Description and Media
Type parameters are displayed especially when there is an existing telnet connection
of the device.
Note - The values displayed by Device Manager for the Receive Limit and Transmit
Limit parameters may not be the same as the values displayed by the CLI.