Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 118)

AlliedView™-EMS 3.11 Device Management Guide Page 118 of 402
Note - The current firmware version does not allow the Status parameter to be set
to 'under change'. Attempting to set it to 'under change' will result in the error
message "The error occurred with 'Set' operation. Error: bad value.".
Note - By default, the Status parameters are set to 'invalid'. To be able to set them
to 'valid', their corresponding IP Address parameters must first be set to valid values.
Failing to do so will result in the error message "The error occurred with 'Set'
operation. Error: time out occured."
Reset
Resets the system
Telnet
Starts a Telnet connection to the hub.
WEB Browser
Connects to the hub's HTTP server.
Hub Menu
From the Hub menu, you can check traffic statistics and hub's status. It also lets you
perform a self-test.
Status
Displays hub information such as stacking status.
Module Menu
From the Module menu, you can view and edit MIB information about a selected hub in the
stacked group.
Status
Displays information such as operation status and object identifier.
Note - The current firmware version returns 'noSuchName' for the following
parameters:
Module Description
Last Update Time and Date
RMON Menu
From the RMON menu, you can view and edit RMON MIB.
Statistics
Displays traffic statistics in the network segment attached to each port.