Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 373)

AlliedView™-EMS 3.11 Device Management Guide Page 373 of 402
Note - The Server Info sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
VoIP Menu
From the VoIP menu, you can view and edit information related to telephony services
available on the residential gateway.
Note - The current firmware version does not provide the information needed by Device
Manager to support the H.323 and SIP protocols.
Profile Info
Displays information related to admin profile.
DTMF Relay
Displays Dual Tone Multi-Frequency (DTMF) relay status.
Note - AT-RG634A: It may take a while before the actual value for the Status
parameter is displayed. The value '???(0)(???(0))' may initially be displayed while
Device Manager is retrieving the actual value from the device.
Media
Displays information related to media transport.
Note - If no VoIP protocol is enabled, the Start Port and Number of Ports
parameters will not be displayed. Instead, a parameter called voipPortRange with a
value of 'noSuchName' will be displayed.
Note - AT-RG600 ADSL: The value displayed for the RTCP Status parameter is
'???(0)(???(0))'.
QoS
Displays Differentiated Service Code Point (DSCP) entries and its QoS priority level.
Note - AT-RG613xx/AT-RG600 ADSL: It may take a while before the actual values
for DSCP and TOS parameters are displayed. The value '0' may initially be displayed
for both parameters while Device Manager is retrieving the actual values from the
device.
MGCP
Protocol Info
Displays general information about the protocol.
Note - Valid MIB Set values for the Default Port parameter are in the range [1024-
2147483647] inclusive. Attempting to set this parameter to a value outside the valid
range will not result in an error but the new value will not be applied.