beautypg.com

Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual

Page 374

background image

AlliedView™-EMS 3.11 Device Management Guide

Page 374 of 402

Note

- When setting the Profile parameter to 'none', the current firmware is

able to set the parameter successfully for the CLI but not for SNMP. As a

result, Device Manager will continue to display the old value.

Note

- The current firmware version does not allow the user to enter

multiple-word values for the NAT IP Address and Interface parameters.

Attempting to do so will result in the error message: "The error occurred

with 'Set' operation. Error: commit Failed."

Note

- Valid MIB Set values for the Max Retransmit Time parameter are in

the range [11-86400] inclusive. However, when the Roundtrip Time

parameter is set to its minimum value of 500, the current firmware version

allows the Max Retransmit Time parameter to be set to a value less than 11.

Note

- AT-RG634A: Valid MIB Set values for the Interface parameter are in

the range [1-75] inclusive. But the current firmware version allows the

parameter to be set to more than 75 characters.

Note

- AT-RG634A: Valid MIB Set values for the NAT IP Address parameter

are in the range [0-255] inclusive. Attempting to set this parameter to a value

outside the valid range will result in the error message: "No access error."

Note

- AT-RG634A: Values displayed on the Protocol Info MIB variable

window may not be consistent with what is set on the device.

Note

- AT-RG634A: Valid MIB Set values for the Interface parameter is in the

range [1-75] inclusive. Attempting to set this parameter to a value outside

the valid range will not result to an error message but will cause the device
to restart.

Note

- AT-RG644B: The current firmware version accepts anywhere from 1

to 67 characters inclusive for the Interface parameter. Attempting to enter a

string value whose length is outside of the valid range will cause the device to

restart and will eventually result in the error message: "The error occurred
with 'Set' operation. Error: time out occurred."


Call Agent Info

Displays a list of all call agents available.

Note

- AT-RG634A: It may take a while before the correct number of call agents are

displayed in Device Manager.