Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 132)

AlliedView™-EMS 3.11 Device Management Guide Page 132 of 402
Note - The current firmware version does not allow the Status parameter to be
configured. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: noSuchName."
Security Secrets
Displays information on the identities and secrets used by the PPP authentication
protocols.
Note -The current firmware version does not allow the Protocol parameter to be
configured. Attempting to configure this parameter will not result in an error but
the new value will not be applied.
Note - Setting the Status parameter to 'invalid' clears the corresponding values of the
Identity and Secret parameters.
Note - Device Manager allows the user to enter up to 63 characters for the Identity
and Secret parameters. Entering more than 63 characters will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note - Security Secrets parameters return to their default values whenever the
device is restarted.
Note - The current firmware version does not allow the Direction parameter to be
configured. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: bad value."
Port Menu
From the Port menu, you can view and edit MIB information about selected ports.
Interface Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status.
Note - The Interface Info sub-menu option displays port parameters for 20 ports. By
default, the Administration Status parameter is set to 'up' for the first four ports and
'down' for the rest of the ports. For ports 1 to 3, the Administration Status
parameter cannot be configured. Its value is fixed to 'up'. For ports 5 to 12, valid
MIB Set values for the Administration Status parameter are 'up' and 'down'.
Attempting to set this parameter to any other value will result in the error message:
"The error occurred with 'Set' operation. Error: bad value."
Note - The Administration Status parameter always returns to its default value
whenever the device is restarted.