Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 325)

AlliedView™-EMS 3.11 Device Management Guide Page 325 of 402
Note - Please refer to Converteon Series Modules for the operations and behavior of the
modules installed on the chassis.
Agent Menu
From the Agent Menu, you can view and edit the system information for the chassis, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - The System Contact and System Name parameters accept inputs of up to 39
characters only while the System Location parameter accepts up to 38. Input values
that exceed these limits will be automatically truncated.
Network Info
Displays network-related information such as the addresses of the default gateway
and the TRAP Destination.
System Config
Displays the device's systems variables.
Note - The Temperature Threshold parameter is not applicable to the AT-CV1200
and should be ignored.
Diagnostics
Displays the device's software version, fan speed and fan temperature.
Reset
Resets the device.
Telnet
Starts a Telnet connection to the chassis.
Status Menu
From the Status Menu, you can view information about Converteon Series Modules
installed on the chassis.
Module Info
Displays the basic module configuration information of the device. Options to view
all/per module information are displayed.
Note - The Module Name parameter serves as the slot name. As such, any value
specified for this parameter will be retained even if the line card occupying the slot is
removed or replaced.