Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 75)

AlliedView™-EMS 3.11 Device Management Guide Page 75 of 402
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Note - The current firmware version does not allow Device Manager to support the
following features:
• Spanning Tree Info
• Class of Service
• IGMP Snooping
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status.
Note - The Port Type parameter returns '???(62)'.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - The current firmware version accepts from 0 up to 19 characters for the Port
Name parameter.
Note - The current firmware version (AT-S25 v2.0.2) supports atiStackSwitch.mib
v1.0. However, Device Manager supports atiStackSwitch.mib v2.13. As a result, the
following additional port parameters will appear:
• Port MDIO
• Port HOL Limit
• Port Back Pressure Limit
• Port STP State
These parameters are defined in v2.13 but will return 'noSuchName.' because they
do not exist in v1.0.