Port menu – Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 270

AlliedView™-EMS 3.11 Device Management Guide
Page 270 of 402
Displays the RMON History table.
Note
- The current firmware version is unable to provide History Control Table
information. As a result, the following error message appears: "Failed to get MIB
data."
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays port statistics such as the number of packets received and transmitted on
the port, bytes received and transmitted on the port and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note
- Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note
- The current firmware version does not allow the Port Alias parameter to be
configured.
Note
- Use SNMP v2c or v3 to view high capacity (HC) port parameter values.
Additional Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Note
- Use SNMP v2c or v3 to view this table.
Error Statistics
Displays error statistics.