Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 291)

AlliedView™-EMS 3.11 Device Management Guide Page 291 of 402
Note - IGMP Config parameters cannot be configured when the Row Status
parameter under IGMP -> MGMD Management -> Router Interface Info is set to
“active”.
VLAN Info
Displays VLAN parameters such as the maximum supported VLANs and maximum
group number per VLAN.
Query Info
Displays IGMP parameters such as the current IGMP query packets which is
captured by this device, as well as the IGMP query packets sent by the device.
Group Info
Displays current information which is captured by the device provided that IGMP
Snooping and IGMP Status of associated VLAN entry are all enabled.
MGMD Management
Router Interface Info
Displays the list of interfaces on which IGMP is enabled.
Note - The current firmware version accepts values in the range [0-255] inclusive for
the Query Maximum Response Time and Last Member Query Interval parameters.
However, if the value entered is not a multiple of 10, the firmware will convert it to
the largest multiple of 10 less than the entered value. Values less than 10 but greater
than 0 will be converted to 10.
Router Cache Info
Displays the list of IP multicast groups for which there are members on a particular
interface.
Note - The Router Cache Info sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of ‘noSuchName’.
VRRP Menu
From the VRRP menu, you can view and edit VRRP-related information such as the current
VRRP version, VRRP status, VRRP statistics and IP addresses associated with VRRP.
Basic Info
Displays basic information such as the particular version of the Virtual Routing
Redundancy Protocol supported by the device and the whether the VRRP-enabled
router will generate SNMP traps.