Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 182

AlliedView™-EMS 3.11 Device Management Guide
Page 182 of 402
duplex' even if the GBIC or SFP module inserted is not capable of 10/100 Mbps
connectivity.
Note
- AT-8550 : The 10/100/1000Base-T twisted pair ports cannot be manually set
to 1000Mbps. However, the current firmware version allows the Port Speed and
Mode parameter for these ports to be set to '1Gbps full-duplex' or '1Gbps half-
duplex'.
Note
- When the Port Speed and Mode parameter is set to 'auto sense', the Port
MDIO parameter is automatically set to 'mdi' and cannot be changed to 'auto mdix'
Note
- AT-8516F/SC: The Port Speed and Mode parameter of the 100Base-FX/SC
fixed ports can only be set to '100Mbps full-duplex'.
CoS
Displays Class of Service parameters and allows you to configure CoS for a port,
change the default mappings of CoS priorites to egress priority queues and configure
a scheduling method for Class of Service.
Note
- Valid MIB Set values for the CoS Queue parameters are:
•
egress-queue-0
•
egress-queue-1
•
egress-queue-2
•
egress-queue-3
Attempting to set these parameters to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note
- The current firmware version accepts values in the range [1-255] inclusive for
the Queue Weight parameters.
QoS
Displays Quality of Service parameters and allows you to configure Flow Groups,
Traffic Classes, and Policies.
Flow Groups
Displays Flow Group parameters used to group similar traffic flows together.
Note
- The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Traffic Classes
Displays Traffic Class parameters used to provide most of the QoS controls.
Note
- The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.