Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 28)

AlliedView™-EMS 3.11 Device Management Guide Page 28 of 402
Note - The current firmware version does not allow Device Manager to detect the presence
or absence of an SFP module in the SFP slot. As a result, the SFP slot on the device image
will always show an SFP image regardless of whether or not an SFP module is physically
present in the slot.
Note - Status information for port 9 will always be reflected on both the RJ-45 port image
and the SFP port image regardless of whether it is the RJ-45 or the SFP port that is actually
in operation. However, if Device Manager detects that the established link speed is less than
1Gbps, only the RJ-45 port image will turn green.
Note - When Global RSTP is enabled, the current firmware version sets the Port State
parameter of inactive ports to 'blocking'. As a result, expect port images for inactive ports
to turn yellow in Device Manager.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - The current firmware version accepts anywhere from 1 up to 64 characters
for the System Contact, System Name and System Location parameters. NULL
values are not accepted.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Manager Address Info
Displays the IP address of the management station.
Note - The current firmware version does not allow the Trap Destination IP
Address parameters to be configured.
DHCP Info
Displays DHCP information including the DHCP System Group and DHCP Timer
Group.
Reset
Resets the switch.