Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 66)

AlliedView™-EMS 3.11 Device Management Guide Page 66 of 402
Note - The current firmware version allows the user to enter up to 64 characters
for the System Contact and the System Location parameters and up to 20
characters for the System Name parameter.
Note - The current firmware version appends a period '.' and the value of the Default
Domain Name parameter to the value of the System Name parameter.
Firmware Info
Displays the firmware version of the switch.
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Manager Address Info
Displays the IP address of the management station.
Device Info
Displays general information about the switch.
Note - The Security Action parameter has a fixed value of 'do nothing' and cannot be
modified.
Note - The Security Configuration parameter has a fixed value of 'disabled' and
cannot be modified.
Note - Valid MIB Set values for the HOL Configuration and Logging Configuration
parameters are 'on' and 'off'. Attempting to set these parameters to any other value
will result in the error message: "The error occurred with 'Set' operation. Error: bad
value".
Note - Valid MIB Set values for the QoS Configuration parameter are:
• mode 1
• mode 2
• mode 3
• mode 4
• mode 5
• mode 6
• mode 7
• mode 8
Attempting to set this parameter to any other value will result in the error message:
"The error occurred with 'Set' operation. Error: bad value".
DHCP Info
Displays the DHCP information about the switch.