Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 300

AlliedView™-EMS 3.11 Device Management Guide
Page 300 of 402
Config
Displays traffic control configuration parameters for every port present in the
switch.
Segmentation
Displays the information that specifies the port with its traffic forward list.
Note
- The current firmware version does not allow the Forward Ports parameter
to be configured.
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring
status, destination port, Ingress source port and Egress source port.
Note
- The current firmware version does not allow the Mirroring Source Port
(Ingress) and Mirroring Source Port (Egress) parameters to be configured.
QoS
Basic Config
Displays QoS parameters and allows enabling of Hol prevention status and setting of
scheduling mechanism.
Scheduling Mechanism
Displays scheduling mechanism parameters.
802.1p Default Priority
Displays the 802.1p default priority table..
802.1p User Priority
Displays the 802.1p user priority class table.
User Priority Regeneration
Displays the regenerated user priorities table.
Traffic Class
Displays the traffic class table.
Outbound Access Priority
Displays the outbound access priority table.
Bandwidth Control
Displays the bandwidth control table.
Note
- Valid MIB Set values for the Receive Rate and Transmit Rate parameters are
in the range [1-10000] inclusive. However, specifying a value greater than 999 will
automatically set these parameters to 999.