Yokogawa Removable Chassis DX1000N - Manual (Page 83)

1-75
IM 04L41B01-17E
Using the Ethernet Interface
1
2
3
4
5
6
App
Index
Sending Commands
Use the dedicated DX commands. The commands that you can use are listed below. For
details about the commands, see chapter 3. For information about the responses to the
commands, see chapter 4.
Connected
Function
Administrator User
Setting function All the commands are available. All the output commands except for
ME and MO and some of the control
commands are available (operations
that are forbidden by the user
privilege settings are not available).
Monitoring function All the output commands except for ME and MO and control commands CM
and CE.
Main Functions and Commands
• Outputting the Most Recent Measured and Computed Data
Command Function
FD The most recent measured and computed data is output in binary or ASCII
format. When the data is output in binary format, only the significands of the
measured and computed data are output. To acquire the correct values, you
must combine the values output by this command with the decimal place
information output by the FE command.
Example: A value of 12.345 is output as “12345” in binary format.
BO When data is output in binary format, this command specifies whether to output
the data from the MSB (most significant bit) or from the LSB (least significant bit).
FE Outputs the decimal place and unit information of the measured and computed
data. This command can be used when data is output in binary format.
• Outputting Measured and Computed Data at a Specific Interval
The DX outputs the data from a FIFO buffer (First-In First-Out; see appendix 5).
Command Function
FF Outputs the significands of the measured and computed data in binary format.
To acquire the correct values, you must combine the values output by this
command with the decimal place information output by the FE command.
See appendix 5, “Flow Chart of the FIFO Data Output.”
BO See the explanation for “Outputting the Most Recent Measured and Computed
Data.”
FE See the explanation for “Outputting the Most Recent Measured and Computed
Data.”
• Outputting Status Information
For information about status information, see chapter 5.
Command Function
IS The status information is output in ASCII format.
IF A status filter is set.
• Starting and Stopping Measurement and Computation
Command Function
PS PS0: memory start, PS1: memory stop
TL TL0: computation start, TL1: computation stop
• Writing Messages
Command Function
MS Writes a registered character string (message).
BJ Writes the specified character string (message).
• Setting the Batch Name
Command Function
BT Sets the batch and lot numbers.
1.12 Using the Setting/Measurement Server