Yokogawa Removable Chassis DX1000N - Manual (Page 61)

1-53
IM 04L41B01-17E
Using the Ethernet Interface
1
2
3
4
5
6
App
Index
Setting the SNTP Server
Carry out the steps below to run the DX as an SNTP server.
◊ Press
MENU (to switch to setting mode), hold down FUNC for 3 s (to switch to basic
setting mode), and select the Menu tab > Communication (Ethernet) > Server >
Server modes
• SNTP
For the SNTP item under Server, select Use or Not (don’t use).
When an SNTP client on the network queries the time information to the DX, the DX
sends the time information.
Port Number
The default value is 123. To change the setting,
◊ Press
MENU (to switch to setting mode), hold down FUNC for 3 s (to switch to basic
setting mode), and select the Environment tab > Communication > Service port.
For the selectable range of port numbers, see section 6.1.
1.8 Synchronizing the Time