Yokogawa Removable Chassis DX1000N - Manual (Page 125)

3-8
IM 04L41B01-17E
Group Command Function Execution Administrator User Page
Name Mode
Setting (continued)
YL Sets the operation of the Modbus master function Basic setting mode Yes No 3-57
YM Sets a transmit command of the Modbus master function Basic setting mode Yes No 3-57
WR Sets the instrument information output Basic setting mode Yes No 3-58
WI Sets the relay operation Basic setting mode Yes No 3-58
WF Sets the Modbus connection limitation Basic setting mode Yes No 3-58
WG Sets an IP address that is allowed to connect via Basic setting mode Yes No 3-59
Modbus
WJ Sets the FTP transfer wait time Basic setting mode Yes No 3-59
WQ Sets PROFIBUS-DP Basic setting mode Yes No 3-59
XE Activates basic settings Basic setting mode Yes No 3-59
YE Activates basic settings (cold reset) Basic setting mode Yes No 3-59
Output Commands
Note
Output commands except BO, CS, and IF cannot be placed in a command sequence.
Group Command Function Execution Administrator User Page
Name Mode
Control
BO Sets the byte output order All modes Yes Yes 3-60
CS Sets the check sum (can only be used during serial All modes Yes Yes 3-60
communications)
IF Sets status filters All modes Yes Yes 3-60
CB Sets the data output format All modes Yes Yes 3-60
CC Disconnects the Ethernet connection All modes Yes Yes 3-60
(can only be used for Ethernet communications)
Setup, measurement, and control data output
FC Outputs screen image data All modes Yes Yes 3-61
FE Outputs setup data All modes Yes Yes 3-61
FD Outputs the most recent measured/computed data Operation mode Yes Yes 3-61
FF Outputs FIFO data Operation mode Yes Yes 3-61
FL Outputs a log, alarm summary, or message summary All modes Yes Yes 3-62
IS Outputs status information All modes Yes Yes 3-62
FU Outputs user levels All modes Yes Yes 3-63
FA Outputs internal DX information All modes Yes Yes 3-63
ME Outputs data stored on the external storage medium Operation mode Yes No 3-63
and internal memory
MO Outputs the data stored in the internal memory. Operation mode Yes No 3-63
Dedicated commands for RS-422/485
Esc O Opens an instrument All modes Yes Yes 3-64
Esc C Closes an instrument All modes Yes Yes 3-64
Common commands among instruments
*I Outputs instrument information All modes Yes Yes 3-65
Maintenance/Test Commands (Available when using the maintenance/test
server function via Ethernet communications)
Command Function Administrator User Page
Name
close Closes another device’s connection Yes No 3-65
con Outputs connection information Yes Yes 3-65
eth Outputs Ethernet statistics Yes Yes 3-65
help Outputs help Yes Yes 3-66
net Outputs network statistics Yes Yes 3-66
quit Closes the connection to the instrument that you are operating Yes Yes 3-66
Instrument Information Output Commands (Available when using the
instrument information server function via Ethernet communications)
Parameter Function Page
Name
serial Outputs the serial number 3-67
host Outputs the host name 3-67
ip Outputs the IP address 3-67
3.2 A List of Commands