Yokogawa Removable Chassis DX1000N - Manual (Page 124)

3-7
IM 04L41B01-17E
Commands
1
2
3
4
5
6
App
Index
Basic Setting Commands
• In order to activate the settings that are changed using the basic setting commands,
the settings must be saved using the YE or XE command. Make sure to save
the settings before changing from the basic setting mode to the operation mode.
Otherwise, new settings will not be activated.
• The settings that are returned in response to a query in basic setting mode contain the
new settings even if they are not saved. However, the new settings are not activated
unless they are saved. If the settings are cleared or if you change from basic setting
mode to operation mode before saving the settings, the settings that are returned
in the response to a query contain the settings that were used before they were
changed.
Note
• The settings that are changed using the YA, YK, RU, YQ, YS, YB, YD, WS, WW,
and WQ commands are activated after saving the new settings using the XE command and
restarting the DX.
• When you execute the YE or YO command, communication is disconnected. Commands
listed after the YO or YE command are ignored.
Group Command Function Execution Administrator User Page
Name Mode
WU Sets the environment Basic setting mode Yes No 3-45
WE Sets calibration management Basic setting mode Yes No 3-47
WO Sets alarm and DO settings Basic setting mode Yes No 3-48
WH Sets alarm hysteresis Basic setting mode Yes No 3-48
XV Sets the scan interval and A/D integral time Basic setting mode Yes No 3-48
XB Sets burnout detection Basic setting mode Yes No 3-49
XJ Sets RJC Basic setting mode Yes No 3-49
XM Sets memory sampling conditions Basic setting mode Yes No 3-49
XT Sets the temperature unit Basic setting mode Yes No 3-49
RF Sets key lock Basic setting mode Yes No 3-49
RN Sets basic key login Basic setting mode Yes No 3-50
RP Sets user limitations Basic setting mode Yes No 3-50
RO Sets the type of report and when to create reports Basic setting mode Yes No 3-51
RM Sets a report channel Basic setting mode Yes No 3-52
XG Sets the time zone Basic setting mode Yes No 3-52
XN Sets the date format Basic setting mode Yes No 3-52
YB Sets host information Basic setting mode Yes No 3-52
YD Sets network parameters Basic setting mode Yes No 3-53
YA Sets the IP address, subnet mask, and default gateway Basic setting mode Yes No 3-53
YK Sets keepalive Basic setting mode Yes No 3-53
RU Sets DNS parameters Basic setting mode Yes No 3-53
WS Sets a server Basic setting mode Yes No 3-53
WW Sets Webpage parameters Basic setting mode Yes No 3-53
YQ Sets communication timeout Basic setting mode Yes No 3-53
YT Sets FTP transfer timing Basic setting mode Yes No 3-54
YU Sets what kind of information to send using e-mail Basic setting mode Yes No 3-54
YV Sets an e-mail recipient address Basic setting mode Yes No 3-55
YW Sets the e-mail sender address Basic setting mode Yes No 3-55
YX Sets the e-mail SNTP server name Basic setting mode Yes No 3-55
YJ Sets the Modbus client’s destination server Basic setting mode Yes No 3-55
YP Sets basic Modbus client settings Basic setting mode Yes No 3-55
YR Sets the Modbus client’s transmit command Basic setting mode Yes No 3-55
WB Sets SNTP client parameters Basic setting mode Yes No 3-56
WC Sets the SNTP operation when memory start is Basic setting mode Yes No 3-56
executed
YS Sets the serial interface Basic setting mode Yes No 3-56
3.2 A List of Commands