Yokogawa Removable Chassis DX1000N - Manual (Page 183)

3-66
IM 04L41B01-17E
Ethernet Statistics
Name In Pkt In Err Out Pkt Out Err 16 Coll
lo0 0
0 0 0 0
mb0 74 0 64 0 0
EN
help Outputs help
Syntax help [,p1]
p1 Command name
(close, con, eth, help, net, quit)
Example
help
EA
con
- echo connection information
eth - echo ethernet information
help - echo help
net - echo network status
quit - close this connection
EN
net Outputs network statistics
Syntax net
Example
net
EA
00/00/00 12:34:56
Network Status
APP: power on time = 00/00/00 12:34:56
APP: applalive = disable
APP: genedrops = 0
APP: diagdrops = 0
APP: ftpsdrops = 0
TCP: keepalive = 30 s
TCP: connects = 14
TCP: closed = 0
TCP: timeoutdrop = 0
TCP: keepdrops = 0
TCP: sndtotal = 53
TCP: sndbyte = 0
TCP: sndrexmitpack = 0
TCP: sndrexmitbyte = 1
TCP: rcvtotal = 0
TCP: rcvbyte = 0
DLC: 16 collisions = 0
EN
TCP: keepalive
Keepalive check cycle
TCP: connects
Total number of connections established
TCP: closed
Total number of closed connections
TCP: timeoutdrop
Total number of closed connections due
to TCP retransmission timeout. When the
transmitted packet is not received, the DX
retransmits the packet at a predetermined
time interval. If the packet is not received after
14 retransmissions, a timeout occurs, and the
connection is closed.
TCP: keepdrops
Total number of closed connections due to
TCP keepalive timeout
TCP: sndtotal
Total number of transmitted packets
TCP: sndbyte
Total number of transmitted bytes
TCP: sndrexmitpack
Total number of retransmitted packets
TCP: sndrexmitbyte
Total number of retransmitted bytes
TCP: rcvtotal
Total number of received packets
TCP: rcvbyte
Total number of received bytes
DLC: 16 collisions
Number of collisions. A collision occurs when
two or more instruments on the network
attempt to transmit simultaneously. The
tendency for collisions to occur increases
when the network is congested. 16 collisions
would mean 16 consecutive collisions.
quit Closes the connection to the
instrument that you are operating
Syntax quit
3.11 Maintenance and Test Commands