Yokogawa Removable Chassis DX1000N - Manual (Page 126)

3-9
IM 04L41B01-17E
Commands
1
2
3
4
5
6
App
Index
When the /AS1 Advanced Security Option Is in Use
DX Execution Modes
The DX has five execution modes. The modes that each command can be executed in
are predetermined. Trying to execute a command in the wrong mode results in a syntax
error. Before executing a command, use a mode switching command to switch to the
appropriate mode. Queries can be executed in any mode. The letters in parentheses in
the titles below are the used to represent the different modes in explanations.
• Basic Setting Mode (B)
Basic setting mode when recording is stopped.
• Basic Setting Mode during Memory Sampling (b)
The basic setting mode that appears during recording.
• Setting Mode (S)
Setting mode when recording is stopped.
• Setting Mode during Memory Sampling (s)
The setting mode that appears during recording.
• Operation Mode (O)
The mode in which operations are performed.
Switching Execution Modes
The figure below indicates the commands that can make the DX switch between different
modes and operation modes.
Basic setting
mode
Operation mode
Basic setting mode
during memory
sampling
Setting Mode
Setting mode
during memory
sampling
Operation mode
(while logged out)
Log in CC CC CC CC CC
YE LO
EE SYS EE ENG EE ENG
BE BE
EE SYS
YE, YO, EC
Note
If there is no CF card in the DX, an error will occur when you change the settings and then
try to switch to operation mode from basic setting mode, basic setting mode during memory
sampling, or setting mode.
3.2 A List of Commands