Yokogawa Removable Chassis DX1000N - Manual (Page 27)

1-19
IM 04L41B01-17E
Using the Ethernet Interface
1
2
3
4
5
6
App
Index
Basic Settings
Set the SMTP server and mail address.
• SMTP server name
Enter the host name or IP address of the SMTP server.
• Port number
Unless specified otherwise, set the number to the default value. The default value is
25.
• Security (release number 3 or later)
Select PbS if you want to enable POP before SMTP. To enable authenticated e-mail
transmission (Authentication SMTP), select Auth (release numbers 4 and later). When
you select Auth, the SMTP authorization items appear.
SMTP authorization (Release numbers 4 and later)
To enable support for authenticated e-mail transmission (Authentication SMTP), set a
user name and password to use for authentication.
• User name
Enter the user name. You can enter up to 32 characters.
• Password
Enter the password. You can enter up to 32 characters.
Recipients
• Recipient1 and Recipient2
Enter the e-mail address. Multiple e-mail addresses can be entered in the box of one
recipient. When entering multiple addresses, delimit each address with a space. Up
to 150 characters can be entered.
• Sender
Enter the sender e-mail address. You can enter up to 64 characters.
POP3 Settings (release number 3 or later)
If you need to use POP before SMTP, specify the POP3 server that will be used for
authentication.
For instructions on how to set the POP3 login method, see “Configuring the POP3 Server
Connection” later in this section.
• POP3 Server name
Enter the POP3 server host name or IP address.
• Port number
Use the default setting unless you need to change it. The default value is 110.
• Login name
Enter the POP3 server login name.
• Password
Enter the POP3 server login password using up to 32 characters.
Alarm Settings
Specify the settings for sending e-mail when alarms occur or release.
• Recipient1 and Recipient2
Set the e-mail recipients. For Recipient1 and Recipient2, select On to send e-mail or
Off to not send e-mail.
• Active alarms
Sends an e-mail when an alarm occurs or releases. You can select On (send e-mail)
or Off (not send e-mail) for alarms 1 to 4.
• Include instantaneous value
Select On to attach instantaneous value data. The data that is attached is the
instantaneous value that is measured at the time the e-mail is transmitted.
1.4 Sending E-mail Messages