Yokogawa Removable Chassis DX1000N - Manual (Page 194)

4-10
IM 04L41B01-17E
Communication Log
• The FL command is used to output the data.
• A log of setting/basic setting/output commands and responses is output. Up to 200
logs are retained. Logs that exceed 200 are cleared from the oldest data.
• Syntax
EACRLF
yy/mo/dd_hh:mm:ss_n_uuu···ufd_mmm···mCRLF
······································
ENCRLF
yy Year (00 to 99)
mo Month (01 to 12)
dd Day (01 to 31)
hh Hour (00 to 23)
mm Minute (00 to 59)
ss Second (00 to 59)
n Connection ID. A number used to identify the user that is connected.
0: Serial
1 to 3: Ethernet
uuu···u User name (up to 20 characters)
f Multiple command flag
Space: Single
*: Multiple
(If multiple commands are separated by sub delimiters and output at
once, “*” is displayed. The multiple commands are divided at each sub
delimiter and stored as individual logs (1 log for 1 command and 1 log
for 1 response.)
d Input/Output
>: Input
<: Output
mmm···m Message (up to 20 characters)
• The communication log contains only the error number and not the
error message section.
• Normally, the transfer data are transmitted as they are, but in some
cases, a special message is output. The special messages are
shown below.
Reception
(Over length): Command length exceeded.
(Over number): Number of commands exceeded.
(Serial error): Received an error character through serial
communications.
4.2 Output Format of ASCII Data