Watlow Series PD - Manual (Page 41)

W a t l o w S e r i e s P D
■
39
■
C h a p t e r 7 C o n f i g u r a t i o n P a g e
Outputs
The Outputs folder contains links for configuring the outputs installed in the Series PD. The controller leaves
the factory with default settings on the Output pages that disable all output functions. To get the Series PD opera-
tional, you must go through the Output links and set up the outputs. The Outputs folder links are:
• Outputs 1
• Outputs 2
• Outputs 3
• Outputs 4
Process Output Configuration Page
The Process Output Configuration pages set the parameters for the process outputs installed. Outputs can be
configured as control outputs, event (alarm) outputs or retransmit outputs. The Process Output Configuration page
is shown below.
You can see and change all of the parameters on the Output Configuration page. Only those that apply will be
relevant. For example, you can set the Retransmit Parameters even though you have the Control Function set to
Control. Only parameters relating to control outputs have any effect on the controller. If you change the Output
Function to Retransmit, the Retransmit Parameters previously entered are used.
Note: You must click Submit to send the new values to the Series PD.
Figure 39 — Process Output Configuration Web Page Example
Note: Red tag arrows and tag numbers are links to item descriptions. Click on a red tag arrow or number to go to a description of the item.