Watlow Series PD - Manual (Page 159)

tag_CL_METHOD 2 Enumerated 113 1 42 UINT
tag_EIP_AI_ERROR_ACK 1
Numeric 113 1 99
WORD
tag_EIP_ALARM_ACTIONS 1 Numeric 113 1 100 WORD
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 1 Numeric 110 1 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 2 Numeric 110 2 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 3 Numeric 110 3 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 4 Numeric 110 4 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 5 Numeric 110 5 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 6 Numeric 110 6 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 7 Numeric 110 7 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 8 Numeric 110 8 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 9 Numeric 110 9 1
STRUCT
OF 8-
BIT CIA
tag_EIP_O2T_DYNAMIC_ASSEMBLY_POINT 10 Numeric 110 10 1
STRUCT
OF 8-
BIT CIA
When using the O
Æ T Dynamic Assembly (Output) the size would be determined by
the tag name being written to. As an example, because the Closed Loop Tuning
Action (formatted as a UINT) is not being written to via the Static Assembly it may be
desired to be able to change to Autotune via the control program using the Dynamic
Assembly. The output assembly size would change accordingly for the given
formats:
- DINT = 6
- INT = 11
2.2.5 EtherNet/IP Indicator Lights
The PD comes equipped with two new LED’s. The LED characteristics are
defined by Open DeviceNet Vendors Association (ODVA).
Module Status Indicator
Indicator State Summary Requirement
Steady Off No power
If no power is supplied to the device, the
module status indicator shall be steady
off.
Figure 2.2.5a
157