Watlow Series PD - Manual (Page 28)

W a t l o w S e r i e s P D
■
26
■
C h a p t e r 6 D e v i c e I n f o r m a t i o n
Figure 26 — Device Information Web Page Tag Descriptions
Tag # Device Information
Configuration Parameters
Section Description
Inputs
1. Universal Input Sensor Type Displays what input hardware is present and input configuration
information. Inputs 1 and 2 are universal analog inputs and will
accept a wide variety of input signals. Input 2 is an ordering op-
tion. See model number information
2. Digital Input Function
Current Transformer Input
Inputs 3 and 4 can be ordered as digital or current transformer in-
puts. See model number information.
Digital Input Function - displays what action is taken when the
digital input condition is satisfied.
Current Transformer Input - displays what CT hardware is pres-
ent and enabled.
INFOSENSE
3. INFOSENSE Data Displays specific sensor data when connected to an INFOSENSE
sensor. The part number, serial number and calibration date in-
formation is retrieved from the INFOSENSE sensor.
4. Measured System
Line Frequency
Displays system power line frequency. If correct frequency is not
detected, single cycle burst firing mode not available. See Features
chapter.
Outputs
5. Output 1-4 Displays what output hardware is present and output configura-
tion information.
Control Loops
6. Loop Action Displays control loop action; heat, cool, heat/cool or off (disabled).
7. Loop Cool Algorithm Displays control loop cool algorithm selected, On/Off or PID.
8. Loop Heat Algorithm Displays control loop heat algorithm selected, On/Off or PID.
Device Identification
9. Device Name Displays the assigned Netbios name. The default device name is
PDXXXXXX, where XXXXXX is the serial number. This name can
be changed on the TCP/IP Settings page in the Network folder.
Not all computer networking configurations support Netbios
names.
10. Part Number Displays the Series PD model number.
11. MAC Address Displays the assigned MAC address. You can also use the MAC
address as another Netbios name to browse the Series PD by us-
ing WATXXXXXX, where XXXXXX are the last six digits of the
MAC address without colons. Not all computer networking config-
urations support Netbios names.