Troubleshooting – Yamaha DME User Manual
Page 496
DME Designer Owner’s Manual
496
Troubleshooting
For the latest information about DME Designer, visit the Yamaha pro audio site at
Symptom
Possible Causes
Corrective Actions
A compile error occurs during
synchronization.
DSP total resource consumption has
exceeded the upper limit.
Delete unneeded components.
The wiring between components is
connected from multiple output terminals
to a single input.
Change the connections so that a single
output is connected to a single input
terminal. Using a matrix mixer or similar
component, gather multiple outputs into
one signal.
Cannot place component. Cannot place
wiring.
You are in online status.
Execute [Go Off-line] on the
synchronization screen to go into offline
status.
The Designer window in not in edit mode. Place a checkmark next to [Edit] on the
[Tool] menu.
The currently logged on user is restricted
from editing.
Logoff, then log in again as a new user,
or as the Administrator. If edit restrictions
are required for a user, place a check in
the [Security]
→ [Edit] checkbox
A user module is not displayed on the
list.
The [File] menu
→ [Preference] →
[ContentsFolder] has been changed, or
the “User Module” folder has been
moved.
Check that there are user module files
(.umf) in the “ContentsFolder” and “User
Module” folders.
Cannot switch configurations in the
Navigator Window.
While online, you cannot not switch to a
configuration different from the current
scene.
If you can switch between scenes, you
will be able to switch configurations.
The user module window does not open,
even when a user module is double-
clicked.
This is a user module saved by selecting
[Open]
→ [User Module Design
Window].
Open the save dialog, select [Open]
→
[User Module Editor], and resave the
user module.
No editor displays after right-clicking on
a card component, and selecting [Open]
from the context menu.
Some cards do not have editors.
No special corrective action.
The message “Reset Config…” is
displayed for a long time in the message
area of the “Synchronization” dialog box.
This is not abnormal. If many scenes are
entered into the DME, processing takes
time.
Wait until processing finishes.
Cannot set the monitor output.
This is because channels connected with
wiring cannot be used as monitor output.
Select an unconnected channel.
Poor meter response.
A large number of DME units displaying
meters in the same device group.
• Close or minimize the component
editor window to reduce the dumber of
DME displays.
• Divide the device group containing
DME units displaying meters.
The MIDI Setup toolbar will not be
displayed.
Stored in the minimized task tray.
Right-click the MIDI Setup icon in the
task tray then click [Show].