Yamaha DME - Manual (Page 481)

Chapter 6 Component Guide
DME Designer Owner’s Manual 481
Fade
Sets the action of the fader when there is a large change in its position during scene recall.
When you turn this ON, the fader moves gradually to the position after the jump. If you turn this OFF, it
immediately jumps to the parameters saved in the recalled scene.
Frequency
Sets a frequency. In the de-esser, this sets the lowest frequency of the signal to be compressed when
the component is operating. In the BPF, HPF, and LPF filters, this sets the cutoff frequency. In the
graphic equalizer, it is also used as the frequency band button.
Gain
Sets the amplification factor for the entire signal level.
Gain Correct
In the Auto-Mixer, automatically controls the output level for the number of open channels. In
situations, where multiple microphones are used, feedback may occur because many channels are
open at the same time. Feedback can be avoided by using gain correct.
Hold (Hold Time)
Sets how long the gate stays open or the ducking remains active once the trigger signal has fallen
below the threshold level.
KeyIn
Turns an input signal connected to a component's KeyIn port into a trigger that activates the
component. You can select the trigger source in components that have KeyIn ports.
Knee
In compressors, de-essers, and expanders, sets the way in which compression or expansion will be
applied after the signal exceeds the threshold. The following range of settings is available: HARD, 1,
2, 3, 4, 5.
If Hard is set, the signal level changes to a straight line following the specified slope when the trigger
signal exceeds the threshold.
If a value between 1 and 5 (5 = softest) is specified, the curve gradually changes when the threshold
is exceeded, producing a more natural sound.
LFE (Sub Woofer Speaker)
This is a special speaker for playing back low frequency sounds.