Yamaha DME - Manual (Page 117)

Chapter 3 Main Panel Window
DME Designer Owner’s Manual 117
• [Scene Change]
The recall status of the specified scene is transmitted via GPI output.
[Parameter] specifies the scene for which the recall status is to be output.
[Threshold] and [Polarity] are not available.
[Terminal] determines how the GPI voltage will be output in response to parameter changes.
• [GPI Lock]
The GPI Lock status is transmitted via GPI output.
[Parameter], [Threshold], and [Polarity] are not available.
[Terminal] determines how the GPI voltage will be output in response to parameter changes.
• [Direct Parameter Value]
GPI output is produced when a component parameter reaches a specified value. [Parameter]
sets the parameter name. [Threshold] sets the parameter value. [Polarity] is unavailable.
[Terminal] specifies the type of GPI output produced.
• [Audio Detector]
The audio signal status detected by the Audio Detector component is output via GPI OUT.
[Parameter] selects the Audio Detector component that will produce GPI output according to
the detected audio signal status. [Terminal] and [Polarity] specify the type of GPI output
produced.
Terminal GPI Output
When the current scene is the same as the scene specified by [Parameter] the output will
be high, and when different the output will be low.
When the current scene is the same as the scene specified by [Parameter] the output will
be low, and when different the output will be high.
A pulse
*1
will be output when the current scene is the same as the scene specified by
[Parameter].
A pulse *2 will be output when the current scene is the same as the scene specified by
[Parameter].
Terminal GPI Output
When GPI Lock is ON the output will be high, and when OFF the output will be low.
When GPI Lock is ON the output will be high, and when OFF the output will be low.
Terminal GPI Output
A high level is output when the value specified by [Parameter] is equal to [Threshold].
A low level is output when the value specified by [Parameter] is equal to [Threshold].
Pulse waveform 1 (*1) is output at the instant the value specified by [Parameter]
becomes equal to [Threshold].
Pulse waveform 2 (*2) is output at the instant the value specified by [Parameter]
becomes equal to [Threshold].
Terminal Polarity GPI Output
Ignored High level while an audio signal is detected, low level while no audio signal
is detected.
Ignored High level while no audio signal is detected, low level while an audio signal
is detected.
Pulse waveform 1 (*1) is output when the status changes from no audio
signal detected to audio signal detected.
Pulse waveform 1 (*1) is output when the status changes from audio signal
detected to no audio signal detected.
Pulse waveform 2 (*2) is output when the status changes from no audio
signal detected to audio signal detected.
Pulse waveform 2 (*2) is output when the status changes from audio signal
detected to no audio signal detected.