Changes from v1.2 to v2.0 – Yamaha DME User Manual
Page 14
Getting Started
DME Designer Owner’s Manual
14
Changes from V1.2 to V2.0
■ General
• Support added for DME8i-C/DME8o-C/DME4io-C, SP2060 units and MY16-CII.
• “Device Groups”, or groups of the same type of device, have been added at the lowest Zone
level.
• It is now possible to have one master device per device group rather than one master device per
zone. This means that it is possible to have multiple master devices in a single zone.
• Group masters can now be assigned regardless of the IP address. This makes it possible to have
multiple device groups at a single network address.
• Configurations can be created and deleted for each device group.
■ Component
• A Feedback Suppressor component has been added. (
• The Speaker Processor component PEQ “Q” parameter now goes to “63”. (
)
■ Main Panel Window
• Firmware and component data can now be updated simultaneously. (
• A Recovery Update function that allows recovery from program corruption has been added.
(
)
• A Component Link function that allows simultaneous linking of all component parameters has
been added. (
)
• Scene Link function that allows simultaneous control of multiple devices in different device
• A Protect function has been added to the scene manager. (
)
• Card settings are no longer included in scene data.
• A Utility window has been added to allow editing of device utility settings. (
)
• The Local Parameter Link display order has been changed. (
)
• Parameter Link operation can now be turned on or off for each device group. (
)
• Compilation and analysis is now possible even if no connections have been made.
• Navigator window hide/show can now be selected from the main window.
• The Event Logger can now display only the event data for a specified device. (
• The GPI terminal names have been changed from [CH] to [PORT].
■ Designer Window
• A hand tool for window movement has been added. The hand tool can be selected via the hand/
arrow icon in the toolbar, or from the [Tools] menu. The hand tool can also be temporarily
selected by holding the spacebar on your keyboard.
• Window magnification and reduction can now be controlled via the mouse wheel while holding
the keyboard “Ctrl” key.
• Horizontal scrolling can be controlled via the mouse wheel while holding the keyboard “Shift” key.
• The Edit Mode on/off can now be changed from the tool bar. (
)
• Scene information now appears in DME objects, and the Scene Manager can be launched from
the scene information display. (
• An [On-line] button has been added to DME objects, and synchronization is now possible.
(
• Sampling frequency display has been added to the resource meter window. (