Yamaha DME - Manual (Page 464)

Chapter 6 Component Guide
DME Designer Owner’s Manual 464
M.Band Dyna.
Two input, two
output 3-band
dynamics
processor, with
individual solo and
gain reduction
metering for each
band. Low Gain -96.0 to +12.0 dB Low band level
Mid Gain -96.0 to +12.0 dB Mid band level
Hi. Gain -96.0 to +12.0 dB High band level
Presence -10 to +10 For positive values, the threshold of the high band is
lowered and the threshold of the low band is
increased. For negative values, the opposite will
occur. When set to 0, all three bands are affected
the same.
Cmp.Thre -24.0 dB to 0.0 dB Compressor threshold
Cmp.Rat 1:1 to 20:1 Compressor ratio
Cmp.Atk 0 to 120 ms Compressor attack
Cmp.Rel 44.1kHz: 6.0ms to 46.0s
48kHz: 5.0ms to 42.3s
88.2kHz: 3ms to 23.0s
96kHz: 3ms to 21.1s Compressor release time
Cmp.Knee 0 to 5 Compressor knee
Lookup 0.0 to 100.0 ms Lookup delay
Cmp.Byp ON/OFF Compressor bypass
L-M XOver 21.2 Hz to 8.00 kHz Low/mid crossover frequency
M-H XOver 21.2 Hz to 8.00 kHz Mid/high crossover frequency
Slope -6 dB, -12 dB Filter slope
Ceiling -6.0 dB to 0.0 dB, OFF Specifies the maximum output level
Exp.Thre -54.0 dB to -24.0 dB Expander threshold
Exp.Rat 1:1 to ∞:1 Expander ratio
Exp.Rel 44.1kHz: 6.0ms to 46.0s
48kHz: 5.0ms to 42.3s
88.2kHz: 3ms to 23.0s
96kHz: 3ms to 21.1s Expander release time
Exp.Byp ON/OFF Expander bypass
Lim.Thre -12.0 dB to 0.0 dB Limiter threshold
Lim.Atk 0 to 120 ms Limiter attack
Lim.Rel 44.1kHz: 6.0ms to 46.0s
48kHz: 5.0ms to 42.3s
88.2kHz: 3ms to 23.0s
96kHz: 3ms to 21.1s Limiter release time
Lim.Byp ON/OFF Limiter bypass
Lim.Knee 0 to 5 Limiter knee
Low ON/OFF Low band solo
Mid ON/OFF Mid band solo
High ON/OFF High band solo
Effect Type Parameter Setting Range Function