Yamaha DME - Manual (Page 271)

Chapter 4 Designer
DME Designer Owner’s Manual 271
■ Connect Multiple Hotspots in a Single Operation
Method 1 Key Combinations
If you hold down the key when finishing dragging, a wire will be drawn at all origin hotspots.
The wire will be connected to the destination hotspot you dragged and those that come after.
Begin dragging from the connection origin hotspot, then press the key after aligning the
mouse pointer with the hotspot you will connect too. A wire will be displayed below the destination
hotspot. Finish dragging while holding the key down.
Method 2 Connect Multiple Selected Hotspots
Select multiple hotspots using + + click or + drag, then drag from one of the
selected hotspots to the destination hotspot. The selected multiple origin hotspots will all be
connected.
Method 3 Using Shortcuts
Press the [F2] key to select the uppermost open hot spot to the right of the selected object and
begin drawing a wire.
Press Key
Multiple Hotspots Selected