Yamaha DME - Manual (Page 419)

Chapter 6 Component Guide
DME Designer Owner’s Manual 419
■ Matrix (Delay Meter/Output Level Meter)
The upper row has delay meters, while the middle row has send level meters. You can view
parameters for all output channels at once.
When you click the output channel number on the matrix, the [Delay Matrix - All Inputs to One
Output] editor window opens. When you click the input channel number on the left side of the
matrix, the [Delay Matrix - One Input to All Outputs] editor window opens.
The matrix is divided into groups. For the 2 Input matrix, each group has two input channels and
four output channels. For the 4 Input matrix, each group has four input channels and four output
channels. Groups in matrixes with more than four inputs are the same as for the 4 Input matrix.
When you place the mouse pointer over a group, its channel numbers are highlighted. Click to
open the [Delay Matrix - Crosspoint] editor window.
4
Block On Turns ON send from all input channels to output buses.
The [ON] button lights up.
5 Off Turns OFF send from all input channels to output
buses.
6 Nominal Resets all send levels, making them 0 dB. The delay
settings are not changed.
7
Minimum Resets all send levels, making them -
∞ dB. The delay
settings are not changed.
Section Name Function
Send Level Meter
Delay Meter
Click to open the [Delay Matrix - All Inputs
to One Output] editor window.
Click to open the [Delay Matrix - One Input
to All Outputs] editor window.
Click to open the “In 1-4 x
Out 1-4” Crosspoint window. Click to open the “In 5-8 x Out
5-8” Crosspoint window. For 2 input matrix, click to
open the “In 1-2 x Out 1-4”
Crosspoint window.