Setting the bond mismatch option, Setting the calcomp sync character, Setting the calcomp resolution (stepsize) – Xerox 8825 User Manual
Page 98: Setting the calcomp default palette, Bond mismatch purpose

8825/8830 Controller Setup Manual for Firmware 6.0
82
Configuring the Printer Setup Defaults (continued)
Setting The Bond Mismatch Option
Bond Mismatch Purpose
This option sets the media size mismatch recovery mode. When set to
SCALING, the printer will scale the print to the nearest paper roll to your
requested print size. When obtaining the correct sheet size is important, you
should specify QUERY. When set to QUERY, the printer pauses until the
correct media is installed. To continue printing other jobs or pages when a
mismatch occurs, you can separately set the option “Mismatch Queuing
Enable” to ON to place the job in a Mismatch Queue for later resolution. If
SUBSTITUTE is selected, the printer will look for a substitute media size or
media type on which to print the requested job in a 1:1 ratio, or scaled to fit
the available media rolls.
Range: SCALING, QUERY, SUBSTITUTE
Default: SCALING
PATH TO BOND MISMATCH OPTIONS
Display
display
press [ENTER], display
SELECTING THE BOND MISMATCH OPTIONS
Press the ENTER key to change option. Press the NEXT key until the
desired mode QUERY or SCALING is displayed, then press the ENTER key.
EXITING BOND MISMATCH OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.