Learning the displays, On-line indicator light, Graphic & message displays – Xerox 8825 User Manual
Page 23: Enter, Previous, Numeric keypad and cancel/clear button, Over the wire software license feature enabling, Over the wire firmware upgrading, Physical characteristics, Electrical requirements

8825/8830 Controller Setup Manual for Firmware 6.0
7
Controller Overview (continued)
Learning the Displays
On-Line Indicator Light
There is one LED (Light Emitting Diode) on the 8825/8830 Printer’s Control
Panel.
The LED which is located below the Display Window is:
LED NAME
FUNCTION
ON-LINE
ON-LINE LED is lit when the printer is set to
accept print jobs through local ports or across the
network. The ON-LINE LED is off when the
printer has been deselected and will not print
jobs*. Select or deselect the On-Line mode by
pressing the ON-LINE button on the Control
Panel.
*
When the 8825/8830 Printer OFF-LINE mode is selected, the
Controller will continue to accept prints jobs until the SDRAM or hard disk is
full. The stored data files will be printed when the ON-LINE mode is selected.
If the ON-LINE button is pressed to select the OFF-LINE mode while
the 8825/8830 Printer is printing a job, the job will complete before switching
to the OFF-LINE mode. During the time the printer continues to print the job,
the ON-LINE LED will blink. When the OFF-LINE mode is allowed, the ON-
LINE LED will be off.
Graphic & Message Displays
The Graphic Display shows an outline of the printer and the Message Display
is a 2 x 40 character LCD window:
DISPLAY
NAME
STEADY ON
FLASHING
GRAPHIC
DISPLAY
Area of printer that is
affected by the fault. Out of
supplies in this area and will
not function.
Low on supplies
in this area, but
will still function.
MESSAGE
DISPLAY
All status, Printer and
Controller fault messages,
and the menus are
displayed here. All printer
faults are displayed first and
then any controller faults.
Indicates cursor
area of display
screen when
menus are
displayed.