Xerox 8825 - Manual (Page 134)

8825/8830 Controller Setup Manual for Firmware 6.0 118
Configuring the Printer Processing Defaults (continued)
Raster Stamp Scaling Mode & Numeric
Option
Purpose of Raster Stamp Scaling Mode & Numeric
The RASTER STAMP SCALING refers to the scaling of the raster stamp size
before it is applied to the printed page. The final result of this scaling
depends on the mode set by the RASTER STAMP SCALING MODE. When
the mode is set to RELATIVE, the raster stamp will be auto-scaled to the
page. When set to relative, the image aspect ratio will be maintained and the
image will not be clipped. When the mode is set to ABSOLUTE, the scaling
value is an absolute scaling percentage applied to the stamp size using the
Printer Control Panel’s Keypad.
The RASTER STAMP SCALING MODE option sets the raster stamp size to
be RELATIVE to the paper size or set to an ABSOLUTE percentage. The
scaling value for both modes is set using the RASTER STAMP SCALING
MODE option.
Range: RELATIVE, or ABSOLUTE
Default: RELATIVE
The RASTER STAMP SCALING NUMERIC option enables scaling to be set
to a range of 10 - 999%.
Default: 100%
PATH TO THE RASTER STAMP SCALING MODE OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed, press ENTER, press NEXT
until is displayed.
SELECTING THE RASTER STAMP SCALING MODE OPTION
Press the ENTER key, then the NEXT key, to change the option. If you
select RELATIVE, press ENTER to confirm, then proceed to EXIT. If you
select ABSOLUTE, press ENTER to confirm, then press NEXT to display
. Press ENTER twice, use the Keypad to input a
percentage, and press ENTER to confirm.
EXITING THE RASTER STAMP SCALING MODE & NUMERIC
OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.