Xerox 8825 - Manual (Page 136)

8825/8830 Controller Setup Manual for Firmware 6.0 120
Configuring the Printer Processing Defaults (continued)
Label X & Y Location Option
Purpose of Label X & Y Location Option
The Label Location X option sets the X position of the lower left corner of the
label on the printed page. The position can be specified as a value in
millimeters or set to LEFT, CENTER, RIGHT, LEADING, or TRAILING
locations relative to the physical paper’s printable area origin. The X
coordinate is determined after any rotation of the label as specified by the
LABEL ROTATE option.
An EXTEND option can be selected for Label Location X, which is used with
the numeric value of Label Location Y to extend the trailing edge of the
printed plot by the number of millimeters specified in the Label Position Y
parameter. The label is then printed in this extended area.
Range: TRAILING, EXTEND, NUMERIC (0 – 30480 mm), LEFT, CENTER,
RIGHT, LEADING
Default: TRAILING
The Label Location Y option sets the Y position of the lower left corner of the
label on the printed page. The position can be specified as a value in
millimeters or set to TOP, CENTER, or BOTTOM locations relative to the
physical paper’s printable area origin.The Y coordinate is determined after
any rotation of the label as specified by the LABEL ROTATE option.
Range: BOTTOM, NUMERIC (0 - 30480 mm), TOP, CENTER
Default: BOTTOM
PATH TO THE LABEL X & Y LOCATION OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed, press ENTER, press NEXT until
or is displayed.
SELECTING THE LABEL X & Y LOCATION OPTION
Press the ENTER key, then the NEXT key, to change the option. If you
select NUMERIC, press ENTER and input numbers on the Keypad. Press
ENTER to confirm.
EXITING THE LABEL X & Y LOCATION OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.