Xerox 8825 - Manual (Page 142)

8825/8830 Controller Setup Manual for Firmware 6.0 126
Configuring the System Administration Parameters (continued)
Setting The Job Accounting Parameters (continued)
PATH TO THE JOB ACCOUNTING PARAMETERS
At the Printer Control Panel when the display shows , press [ON-
LINE]. When the display shows , press [ENTER]. When the
display shows , press [NEXT] until ADMINISTRATION> is displayed. Press [ENTER] and, using the numeric
keypad, input the required “password,” press [ENTER] again. If ACCOUNTING> is not displayed, press [NEXT] until it is, then press
[ENTER]. Press [NEXT] to display your choice of “Accounting Administration,
“Printer Accounting Mode,” or “Reports.” Press [ENTER] to enter the
submenu of your choice, followed by use of the [NEXT] key to display
submenu choices. Use the [ENTER] and [NEXT] keys as required to enter
parameter setting submenus and view choices within the various submenus.
Press [ENTER] to confirm your choices and [EXIT} to escape from the
current menu. Press [ON-LINE] to place the printer back on line when done.
REFERENCE FOR ADDITIONAL INFORMATION
For complete descriptive information on all Job Accounting parameters, refer
to the Job Accounting Administrator’s Manual.