Path to hpgl emulation options, Selecting the hpgl emulation options, Exiting hpgl emulation options – Xerox 8825 User Manual
Page 87: Hpgl emulation option comments, The purpose of the parallel option, Setting the controller parallel port either on o, Vellum mismatch purpose, Path to vellum mismatch options

8825/8830 Controller Setup Manual for Firmware 6.0
71
Configuring the Printer Setup Defaults (continued)
PATH TO HPGL EMULATION OPTIONS
Display
display
press [ENTER], display
SELECTING THE HPGL EMULATION OPTIONS
Press the ENTER key to display MODE and press ENTER. Press the NEXT
key to toggle between HPGL2 or HPGL758X, then press the ENTER key with
the desired selection displayed.
Press the NEXT key to display EOP DETECTION, then press the ENTER
key. Use the NEXT key to display commands and the NEXT and ENTER
keys to change values and confirm changes.
Press the EXIT key to return to the HPGL menu where by pressing the NEXT
key you can toggle to
submenus. Use the ENTER key to enable changes and the NEXT key to
display options.
Press the EXIT key to return to the HPGL menu, then press the NEXT key to
display
enable changes and the NEXT key to display options. Press the ENTER key
to confirm your selection and return to the HPGL Emulation options.
Press the NEXT key to display
the ENTER key to enable changes and the NEXT key to display options.
Press the ENTER key to confirm your selection and return to the HPGL
Emulation options.
EXITING HPGL EMULATION OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.
HPGL EMULATION OPTION COMMENTS
The HPGL emulation of the Controller must be set to expect HPGL jobs as
either HPGL/2, or HPGL/HP7585.
Most terminator commands are supported and may be set via the 8825/8830
operator control panel or remotely using the Xerox Printer Manager Tool
software.
HP-RTL is supported for most input color modes and all compression
methods. Color source files are half-toned when printed on the 8825/8830
printer. The HP-RTL data format is supported as an extension of the
HPGL/HPGL2 interpreter. This method allows HP-RTL data embedded
within HPGL/2 jobs to be processed.
Both HPGL and HPGL/2 are supported with user-defined printer pen palettes.
These palettes allow the end user to specify width, color, and pattern for an
assigned pen number. The 8825/8830 printer renders the color attribute of
the palette as levels of gray scale.
There are eight user-definable palettes (1 - 8), and one factory default palette
(palette 0) which cannot be changed. The 8825/8830 printer control panel
menu may be used to define the palette content as well as assign the palette
number for each of the four relevant data format interpreters (HPGL/2, CGM,
VDS/VRF and VDS/ordered vector format).
The user-defined palettes may be remotely modified by using Xerox Printer
Manager Tool software. Pen width, pattern, and color can all be controlled
individually for each pen.
You may also set the job or the palette to control the attributes per pen and
per attribute.