Preparing the vpi port, Vpi port, Enable controller vpi port – Xerox 8825 User Manual
Page 41: Network protocols supported, Software supported, Data formats supported, Vpi cable description, Vpi connector pin out, Netbeui, Windows 95/98 platform

8825/8830 Controller Setup Manual for Firmware 6.0
25
Controller Overview (continued)
Preparing The VPI Port
VPI Port
To use the VPI port requires a workstation with a VPI interface card and
appropriate software. An optional card is also required for use with the 8825
EV4 Controller.
Enable Controller VPI Port
Use the Setup I/O Ports menu of the Printer Control Panel to enable the VPI
port.
Network Protocols Supported
Does not apply to the VPI port.
Software Supported
• ServeWare
• VGS (in Xerox 150 Emulation Mode)
Data Formats Supported
• Xerox 150 Emulation
• Versatec Raw Raster
• VDS
• VCGL
VPI Cable Description
The maximum length of a VPI cable must not exceed 1000 feet (304.8 m).
VPI Connector Pin Out
Connector
Pin Number
Signal Name
Connector
Pin Number
Signal Name
1
IN01+
20
IN01-
2
IN02+
21
IN02-
3
IN03+
22
IN03-
4
IN04+
23
IN04-
5
IN05+
24
IN05-
6
IN06+
25
IN06-
7
IN07+
26
IN07-
8
IN08+
27
IN08-
9
RCLEAR-
28
RCLEAR+
10
PICLK+
29
PICLK-
11
READY-
30
READY+
12
PRINT+
31
PRINT-
13
No Connect
32
INOP-
14
RSPP-
33
RSPP+
15
RESET-
34
RESET+
16
RFFED-
35
RFFED+
17
REOT-
36
REOT+
18
RLTER-
37
RLTER+
19
INOP+