Xerox 8825 User Manual
Page 27

8825/8830 Controller Setup Manual for Firmware 6.0
11
Controller Overview (continued)
Software License Feature Enabling (continued)
Effect of Purchased Hardware on the Need to Enable Software License
Features
The need to enable Software License Features depends upon purchased
equipment as stated below:
Scan-to-Net Licensed Feature
If this feature is desired, a Scan-to-Net license is required for all systems
using a 7346 scanner (such as the 8825 DDS). The license is not required
for systems using a 7356 scanner (such as the 8830 DDS) assuming a
firmware level of 2.5 or higher. When the feature is disabled, the “Ready to
Scan” display on the DDS Control Panel will read “Scan Mode Disabled.”
Job Accounting Licensed Feature
If this feature is desired, a Job Accounting license is required for all 8825
systems. The license is not required for 8830 systems assuming a firmware
level of 4.0 or higher. When the feature is disabled, Job Accounting PJL
(printer job language) commands will return an error message. Job
Accounting functions on the Printer Control Panel will be unavailable. Job
Accounting functions on the DDS Control Panel will be unavailable.
PostScript 3 with PDF Printing
If this feature is desired, a license is required for all 8825/8830 systems.