Xerox 8825 - Manual (Page 24)

8825/8830 Controller Setup Manual for Firmware 6.0 8
Controller Overview (continued)
Learning the Control Panel Buttons
ON-LINE
If the printer is On-line (operating), pressing this key will pause the
printer. Jobs will still be accepted from the various host interfaces
and spooled to DRAM or hard disk; however, print data will not be
sent to the print engine. When the printer is not paused, the
associated LED next to this button will be lit. Taking the printer Off-
line will not abort the currently printing page; it will print to
completion. During the interval between when the Off-line state
was requested and the currently printing job completes, the Off-
line LED will blink. Pressing this key when the printer is in any
setup menu will cause the printer to exit the menu and directly
return to On-line. Pressing this key when the printer is Off-line and
not in the menu will also cause the printer to return to On-line.
LANGUAGE
This key switches the display language from the primary
language to the secondary language. A second language option
must be installed in the printer for this function to operate.
MEDIA
This key enables the user to specify the new media installed in the
printer. This is a print engine setup and does not change any
controller setup modes.
EXIT
In menu mode, this EXIT key returns the user to the next higher
level in the menu tree. When in a menu, the ENTER key must be
pressed prior to pressing the EXIT key for the selected operation to
be performed. The EXIT key may therefore be used to “cancel” a
selected operation. At the top level of the menu, pressing the EXIT
key results in going to the printer paused display.
ENTER
In the menu mode, the ENTER key confirms the currently displayed
menu item. If this item is at the end of the menu tree and represents an
actual selection of a setting or parameter, then the selection is executed.
If this item is an intermediate or top-level node in the menu tree, the
selected “branch” of the menu tree is descended. When not in the
printer menu, you may enter the top level of the menu by pressing this
key after pressing the OFF-LINE key.
NEXT
In a menu mode, this key advances the LCD display to the next item in
whatever menu is currently being displayed. It operates in a “wrap-
around” fashion.