Xerox 8825 - Manual (Page 122)

8825/8830 Controller Setup Manual for Firmware 6.0 106
Configuring the Printer Processing Defaults (continued)
Setting the Paper Size Detect Set (use
marked area) Option
Paper Size Detect Purpose
Note: This parameter only affects HPGL and HPGL/2 jobs.
When PAPER is set for auto size detection (ANY, ANY ANSI, ANY ARCH, or
ANY ISO), this parameter determines whether the size of the image used to
determine paper size and image placement is taken from the actual bounding
box of marks on the page (DRAWN AREA), or specified by data format
dependent, page size commands if available (PLOT SPECIFIED).
Range: DRAWN AREA or PLOT SPECIFIED
Default: PLOT SPECIFIED
If the paper size detect option is set to DRAWN AREA, the printed image will
be placed on the smallest size media possible. One possible drawback
arises if the drawn area is larger than the page size specified in your print job.
In this case the printed image will be cropped to the page size specified in
your print job. If the paper size detect option is set to PLOT SPECIFIED, the
image will always be printed to the page size you specify in your print job.
PATH TO PAPER SIZE DETECT OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE PAPER SIZE DETECT OPTION
Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections, and when the desired selection is displayed, press the
ENTER key.
EXITING THE PAPER SIZE DETECT OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.