Configuring the finisher settings, Setting the job accounting parameters, Purpose – Xerox 8825 User Manual
Page 148: Job accounting menu overview
8825/8830 Controller Setup Manual for Firmware 6.0
132
Configuring the Printer Menu Options (continued)
Configuring The Finisher Settings
Purpose
This parameter is set by a Customer Service Engineer at the time that new
equipment is first set up at your site. If you purchased a finishing device
(folder), this parameter must be set to the correct value to enable you to fold
with the newly attached device.
The range of selections includes: None (no finisher), 001 (Xerox 8830
folder), 002 (reserved for future folder), 003 (GFI folder).
To use your new folder, make sure that the appropriate setting has been
selected.
Important Note: Your printer must have an IOT Board Tag 27 installed to
support the new Generic Finisher Interface (GFI) folders. Check with
your Service Representative to verify that your printer is correctly
equipped.
PATH TO THE FINISHER SETTINGS
At the Printer Control Panel when the display shows
LINE]. When the display shows
display shows
displayed. Press [ENTER]. Press [NEXT] until
displayed. Press [ENTER] twice. Use the [NEXT] key to move through the
available selections. Press [ENTER] to confirm your selection. Press [EXIT]
to escape the current menu. Press [ON-LINE] to put the printer back on line.