Setting the tcp/ip options, Path to the postscript partition parameter, Making the postscript partition selection – Xerox 8825 User Manual
Page 69: Path to displaying the mismatch queue, Configuring the system communication defaults, Scsi purpose, Setting the scsi device target number, This option sets the bus termination as required, The tcp/ip purpose

8825/8830 Controller Setup Manual for Firmware 6.0
53
Configuring the System Communication Defaults
(continued)
Setting The TCP/IP Options
The TCP/IP Purpose
The purpose of these options is to set any of the Controller Ethernet network
interfaces to be used with the TCP/IP protocol.
A 3003-XTP NIC option (legacy card on N5T), or a 10/100 Ethernet port
(standard on all Controllers) is required equipment, with an appropriate
network cable attached to same.
ENABLING THE ETHERNET CARDS/PORT TO USE THE TCP/IP
PROTOCOL
Range: PRINTER, ADVANCED, or OFF
Default: PRINTER
PRINTER = 3003-XTP NIC is TCP/IP enabled.
ADVANCED = 10/100 Ethernet card/port is TCP/IP enabled. This advanced
setting must be used to support scanning to the Net and workstation use of
the Web PMT (requires Firmware release 4.0).
SETTING THE IP ADDRESS OF THE PRINTER ON THE NETWORK
Range: String of the form nnn.nnn.nnn.nnn.
Default: “13.240.20.38”
SETTING THE TCP/IP GATEWAY ADDRESS OF THE PRINTER ON THE
NETWORK
Range: String of the form nnn.nnn.nnn.nnn.
Default: “255.255.255.255”
SETTING THE TCP/IP MASK ADDRESS OF THE PRINTER ON THE
NETWORK
Range: String of the form nnn.nnn.nnn.nnn.
Default: “255.255.252.0”
Note: This value means “there is no gateway used on this network.” Never
set this value to 0.0.0.0; doing so can disrupt operations on your network.
The workstations connected to the printer should be assigned the same
values for the TCP/IP MASK parameter. In the case where the workstation
and controller for a separate small network, the factory default value can be
used.
ENABLING THE DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP)
FOR SETTING THE IP ADDRESS
(used if an IP address is supplied by a remote network server)
Range: ON or OFF
Default: is OFF.
Enables dynamic IP address assignment with the DHCP protocols.
Range: ON or OFF
Default: OFF
ENABLING THE BOOTP/RARP OPTION
(used if an IP address is supplied by a remote network server)
Range: ON or OFF
Default: is OFF.
Enables dynamic IP address assignment with the RARP and/or BOOTP
protocols.
Note: If using either BOOTP/RARP or DHCP to enable dynamic assignment
of a TCP/IP address to the Controller, see the Xerox 8825/8830 Network
Administrator Guide for more information.