Xerox 8825 - Manual (Page 97)

8825/8830 Controller Setup Manual for Firmware 6.0 81
Configuring the Printer Setup Defaults (continued)
Setting The PostScript Default Media
Size Option
This parameter is used for those PostScript files that do not specify an output
size. Valid values are specific sheet sizes supported by the Controller. ROLL
sizes and the ANY selection cannot be used. The available range is: ANSI A,
ANSI B, ANSI C, ANSI D, ANSI E, ARCH A, ARCH B, ARCH C, ARCH D,
ARCH E, ARCH 30, ISO A0, ISO A1, ISO A2, ISO A3, ISO A4, ISO B1, ISO
B2, ISO B3, or ISO B4. Note that unlike the “abstract” CGM file format,
PostScript output does not automatically scale the printed image to the
default media size. If the image is larger than this default media size, clipping
will occur.
Default: ANSI A
Path to the PostScript option
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is displayed,
press [ENTER], display , press [NEXT] until
is displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE DEFAULT MEDIA SIZE OPTION
Press the ENTER key to display DEFAULT PAPER SIZE. Press ENTER,
then the NEXT key to toggle through available paper sizes. Press the
ENTER key with the desired selection displayed.
EXITING THE POSTSCRIPT OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.