beautypg.com

Preparing the 3003-xtp nic ethernet port, Ethernet port (legacy nic for n5t controller), Enabling the controller ethernet port – Xerox 8825 User Manual

Page 43: Network protocols supported, Tcp/ip, Novell netware (ipx/spx), Ethertalk, Netbeui, Vpi cable description, Vpi connector pin out

background image

8825/8830 Controller Setup Manual for Firmware 6.0

27

Controller Overview (continued)

Preparing The 3003-XTP NIC Ethernet
Port

Ethernet Port (Legacy NIC for N5T Controller)

The optional, 3003-XTP Network Interface Card (NIC) provides connectivity
to two standard Ethernet type networks. 10Base2 (BNC Thinnet) and
10BaseT (Twisted Pair RJ-45) connectors are both available and the NIC
auto-senses the active connector.

To print using this port your workstation must have a Network Interface card
installed, protocols enabled, and appropriate software running. For complete
setup details see the 8825/8830/8855 Network Administrator’s Guide
available on the Internet at www.xes.com.

Note: All Controllers now use an optional, external Ethernet adapter
attached to the Controller's parallel port, to support TCP/IP, IPX/SPX, and
NetBEUI protocols. Contact your XES sales or service representative for
specific ordering and setup information.

Enabling the Controller Ethernet Port

Use the Setup I/O Ports menu of the Printer Control Panel to set the Ethernet
“Port Enable” to PRINTER, and set a protocol compatible with your network.

Refer to your Network Administrator or the 8825/8830/8855 Network
Administrator's Guide (available at

www.xes.com

) for additional information.

NETWORK PROTOCOLS SUPPORTED

TCP/IP

• lpr/lpd
• TFTP
• Telnet

Dynamic Host Configuration via:

− DHCP
− RARP/BOOTP

Novell NetWare (IPX/SPX)

Auto sensing of frame types:

• Ethernet 2, Ethernet SNAP, 802.2, and 802.3
• Bindery

mode

• NDS

mode

EtherTalk

Phase I and Phase II

NetBEUI

Native MS NetBEUI