beautypg.com

Viewing the system configuration defaults, Making a test print, Test print purpose – Xerox 8825 User Manual

Page 61: Path to test print utility, Making test print selection, Exiting test print utility, Setting the controller serial port parity, Path to the serial options, Selecting the serial options

background image

8825/8830 Controller Setup Manual for Firmware 6.0

45

Viewing The System Configuration
Defaults

Making a Test Print

TEST PRINT PURPOSE

The purpose of Test Prints is to provide a record of current system settings
for use in daily operations, Network Communications setup, and restoration
of desired parameters in cases of unexpected change (such as through
accidental use of the Restore Factory Default utility). TEST PRINT sets
should be made at the following times:

• When the initial install is complete and default settings are defined.
• Anytime that default settings have been changed.
The reference sets of the TEST PRINT pages should be stored with the
machine service log, behind the front door of the 8825/8830 printer.

NOTE: The printer must have bond paper installed to enable the printing of
any TEST PRINT. When bond paper is not present (vellum or film only
installed in the printer) the TEST PRINT must be canceled.

PATH TO TEST PRINT UTILITY

Display , press [ON-LINE], display , press [ENTER],
display , press [ENTER], display

MAKING TEST PRINT SELECTION

Press the NEXT key to toggle through ALL, PRINTER CONFIGURATION,
PRINTER SETTINGS, PEN PALETTES or POSTSCRIPT selections. When
the desired selection is displayed press the ENTER key to enable the
function.

The TEST PRINT will not be run until the 8825/8830 printer is placed back to
the ON-LINE condition.

EXITING TEST PRINT UTILITY

Press the ON-LINE key to go back to ON-LINE mode and print the TEST
PRINT(s).